Yamaha MT-03 Service Manual page 185

3. Install:
• Rear shock absorber assembly "1"
(into the frame support bracket)
• Flange bolt "4"
• Bar cross "5"
NOTE:
Tighten the flange bolt into the bar cross until
just touching. Do not fully tighten the bolt.
4. Install:
• Special washer "6"
(into the bolt "7")
NOTE:
Take care of placing the special washer in the
correct side and tighten the bolt into the bar
cross until just touching.
5. Tighten:
• Flange nut "3"
Rear shock absorber assembly
nut (rear side)
50 Nm (5.0 m·kg, 36 ft·lb)
• Flange bolt "4"
Rear shock absorber assembly
bolt (front side)
155 Nm (15.5 m·kg, 112 ft·lb)
REAR SHOCK ABSORBER ASSEMBLY
6. Rotate:
• Special washer "6"
(clockwise until clearance with the abutment
is completely recovered)
7. Tighten:
• Bolt "7"
(keep the special washer in its position with
one finger)
4-62
Bar cross rear bolt
155 Nm (15.5 m·kg, 112 ft·lb)