Checking The Brake Fluid Level - Yamaha MT-03 Service Manual

Locknut
18 Nm (1.8 m·kg, 13 ft·lb)
WARNING
A soft or spongy feeling in the brake pedal
can indicate the presence of air in the
brake system. Before the vehicle is operat-
ed, the air must be removed by bleeding
the brake system. Air in the brake system
will considerably reduce braking perform-
ance and could result in loss of control and
possibly an accident. Therefore, check
and, if necessary, bleed the brake system.
CAUTION:
After adjusting the brake pedal position,
make sure there is no brake drag.
EAS00115

CHECKING THE BRAKE FLUID LEVEL

1. Stand the motorcycle on a level surface.
NOTE:
• Place the motorcycle on a suitable stand..
• Make sure the motorcycle is upright.
2. Check:
• Brake fluid level
Below the minimum level mark "a"
recommended brake fluid to the proper level.
Recommended brake fluid
DOT 4
A. Front brake
B. Rear brake
A
B
WARNING
• Use only the designated brake fluid. Other
brake fluids may cause the piston seals to
deteriorate, causing leakage and poor
brake performance.
• Refill with the same type of brake fluid
that is already in the system. Mixing brake
fluids may result in a harmful chemical re-
action, leading to poor brake perform-
ance.
• When refilling, be careful that water does
not enter the brake fluid reservoir. Water
will significantly lower the boiling point of
the brake fluid and could cause vapor
lock.
CAUTION:
Brake fluid may damage painted surfaces
and plastic parts. Therefore, always clean
Add the
up any spilt brake fluid immediately.
NOTE:
In order to ensure a correct reading of the
brake fluid level, make sure the top of the
brake fluid reservoir is horizontal.
a
3-19
CHASSIS
a