Engine Removal; Installing The Engine; Engine Alignment Tool - Yamaha MT-03 Service Manual

EAS00192

INSTALLING THE ENGINE

1. Install:
• Engine (on the frame)
• Special tool "1"
NOTE:
Insert the special tool "1" in its position until it is
engaged to the special nut grooves "2".

Engine alignment tool "1"

90890-11097
2. Install:
• Engine rear mounting bolt/nut "3"
(tighten the nut until just touching the
bracket)
• Engine front bracket "4"
• Engine front bracket bolts/nuts "5"
(tighten the nuts until just touching the
bracket)
• Engine front mounting bracket bolts/nuts "6"
(tighten the nuts until just touching the
bracket)
• Engine upper bracket (left) "7"
• Engine upper bracket (right) "8"
• Engine upper bracket bolts/nuts "9"
(tighten the nuts until just touching the
bracket)
• Engine upper mounting bolt/nut "10"
(tighten the nut until just touching the
bracket)
NOTE:
Do not fully tighten the bolts.
3. Tighten:
• Special nut "2"
(using the special tool "1")
Special nut "2"
18 Nm (1.8 m·kg, 13 ft·lb)
NOTE:
Leave the special tool in its position and start
tightening all nuts to the indicated torque ac-
cording to the sequence indicated.
4. Tighten:
• Engine rear mounting bolt/nut "3"
• Engine front bracket bolt/nut (upper) "5"
• Engine front bracket bolt/nut (lower) "5"
• Engine front mounting bracket bolt/nut
(upper) "6"
• Engine front mounting bracket bolt/nut
(lower) "6"
• Engine upper bracket bolt/nut (front) "9"
• Engine upper bracket bolt/nut (rear) "9"
• Engine upper mounting bolt/nut "10"
5-7

ENGINE REMOVAL