Checking The Rear Brake Master Cylinder; Assembling The Rear Brake Master Cylinder - Yamaha WR450FN 2022 Owner's Service Manual

tem.
1. Remove:
• Union bolt
• Copper washer
• Brake hose
TIP
To drain any remaining brake fluid, place a con-
tainer under the master cylinder and the end of
the brake hose.
EAM30049
CHECKING THE REAR BRAKE MASTER
CYLINDER
1. Check:
• Brake master cylinder "1"
Damage/scratches/wear  Replace.
• Brake fluid delivery passages "2"
(brake master cylinder body)
Obstruction  Blow out with compressed air.
1
2. Check:
• Master cylinder reservoir cap
Crack/damage  Replace.
• Brake master cylinder reservoir diaphragm
holder
• Brake master cylinder reservoir diaphragm
Crack/damage  Replace.
3. Check:
• Brake hose
Cracks/damage/wear  Replace.
EAM30050
ASSEMBLING THE REAR BRAKE MASTER
CYLINDER
EWA13520
WARNING
• Before installation, all internal brake com-
ponents should be cleaned and lubricated
with clean or new brake fluid.
• Never use solvents on internal brake com-
ponents.
Specified brake fluid
DOT 4
1. Wash the brake master cylinder with brake
2. Install:
• Primary cylinder cup "1"
• Secondary cylinder cup "2"
EWA19300
Apply brake fluid to the cylinder cups and in-
stall them as shown. Wrong orientation in in-
stallation causes poor braking performance.
2
3. Install:
• Spring "1"
TIP
Install the spring with a smaller inside diameter
to the brake master cylinder piston.
4. Install:
• Brake master cylinder piston assembly "1"
• Push rod "2"
• Circlip "3"
4-35
REAR BRAKE
fluid.
(to the brake master cylinder piston "3")
WARNING
1
1
(to the brake master cylinder piston "2")
1
2
3
2
3
2