Yamaha MT-03 Service Manual page 168

8. Install:
• Handlebar grip "1"
a. Apply a thin coat of rubber adhesive onto the
left end of the handlebar.
b. Slide the handlebar grip over the left end of
the handlebar.
c. Wipe off any excess rubber adhesive with a
clean rag.
EWA13700
WARNING
Do not touch the handlebar grip until the
rubber adhesive has fully dried.
NOTE:
There should be 1-3 mm (0.04-0.12 in) of clear-
ance "a" between the handlebar grip and the
grip end.
9. Install:
• Cable ties "1"
(secure the left handlebar switch lead)
• Cable ties "2"
(secure the right handlebar switch lead)
• Grip ends "3"
• Bolt caps "4"
Grip end bolt
23 Nm (2.3 m·kg, 17 ft·lb)
3
1
4
2
4-45
NOTE:
Refer to "CABLE ROUTING" on page 2-40.
10. Install:
• Band "1"
(secure the clutch cable)
• Piece connecting "2"
A
1
2
C
NOTE:
Refer to "CABLE ROUTING" on page 2-40.
11. Install:
• Left rear view mirror "1"
• Right rear view mirror "2"
1
HANDLEBAR
B
D
2