Assembling The Front Wheel; Adjusting The Front Wheel Static Balance - Yamaha MT-03 Service Manual

4. Check:
• Wheel bearings
Front wheel turns roughly or is loose
place the wheel bearings.
• Oil seals
Damage/wear Replace.
EAS21960

ASSEMBLING THE FRONT WHEEL

1. Install:
• Wheel bearings
New
• Oil seals
New
a. Install the new wheel bearings and oil seals
in the reverse order of disassembly.
EC5YU1001
CAUTION:
Do not contact the wheel bearing inner race
"1" or balls "2". Contact should be made
only with the outer race "3".
NOTE:
Use a socket "4" that matches the diameter of
the wheel bearing outer race and oil seal.
EAS21970
ADJUSTING THE FRONT WHEEL STATIC
Re-
BALANCE
NOTE:
• After replacing the tire, wheel or both, the
front wheel static balance should be adjusted.
• Adjust the front wheel static balance with the
brake disc installed.
1. Remove:
• Balancing weight(s)
2. Find:
• Front wheel's heavy spot
NOTE:
Place the front wheel on a suitable balancing
stand.
a. Spin the front wheel.
b. When the front wheel stops, put an "X
mark at the bottom of the wheel.
c. Turn the front wheel 90° so that the "X
mark is positioned as shown.
d. Release the front wheel.
e. When the wheel stops, put an "X
the bottom of the wheel.
4-9
FRONT WHEEL
" mark at
2
"
1
"
1