Magnetic Stripe Option; Magnetic Stripe Circuit Board - DataCard CP60 Service Manual

Magnetic Stripe Option

Magnetic Stripe Circuit Board

Removal Procedure
1.
Unplug the printer.
2.
Remove the ribbon cartridge and cleaning roller.
3.
Remove the
4.
Remove the
5.
Unplug the magnetic stripe head and encoder cables from the magnetic stripe
board.
6.
Remove the magnetic stripe circuit board from the main control board by
lifting the board off all three connectors simultaneously.
Replacement Notes
• There is no built-in alignment mechanism between the main control board
and the daughter board.
• Using the Diagnostics in chapter 5, calibrate the magnetic stripe head as
described in Start Sentinel Position.
CP60 and CP60 Plus Service Manual
Main Enclosure
Transport Assembly
Make sure the connectors between the two boards are aligned properly. If
not, both boards could be damaged.
(p. 6-8).
from the base (p. 6-29).
6-75