Table of Contents
Advertisement
Cam Sensor
Removal Procedure
1.
Unplug the printer.
2.
Remove the ribbon cartridge and cleaning roller.
3.
Remove the
4.
Remove the
5.
Close and lock the swingarm, and turn the printer upside down.
6.
Rotate the printhead cam until the cam flag is clear of the sensor.
7.
Remove the sensor:
A.
B.
C.
Replacement Notes
•
Make sure the sensor is fully seated. The edge of the sensor arm should be
against the edge of the chassis.
•
Refer to the
replacement details.
•
Run the Printhead Cam Test in Diagnostics to verify the sensor is functional.
CP60 and CP60 Plus Service Manual
Main Enclosure
Transport Assembly
Place a screwdriver into the removal access slot, and push the sensor out.
Only when the sensor is partially removed (loose) is it acceptable to push
against the sensor arm or pull with the wires.
Disconnect the sensor cable connector from the main control board.
Front Wire Routing
(p. 6-8).
from the base (p. 6-29).
and
Functional Block Diagram
for
6-21
Advertisement
Table of Contents
Troubleshooting
