DataCard CP60 Service Manual page 73

Error
Code
DR 00903 Error processing this card. Click Help
for steps to follow.
DR 00904 PC to printer communication error.
Check the data cable.
DR 00906 Printer driver error. Click Help for
more information.
DR 00907 The printer driver cannot access the
required PC resources. Click Help for
more information.
DR 00908 The printer driver cannot get enough
PC memory. Click Help for more
information.
DR 00909 Printer driver error. Click Help for
more information.
DR 00910 The printer firmware needs to be
updated. Click OK to update
firmware now.
DR 00912 The printer driver was not installed
successfully. Click Help for steps to
follow.
CP60 and CP60 Plus Service Manual
Message text Comments
The driver has failed to create or access the
temporary files containing the data for the card.
• Make sure the TEMP environment variable is set
correctly. User should have sufficient rights to
write to this folder.
• Make sure there is enough free disk space to
store the necessary card data.
Check for possible PC configuration failures such
as:
• Defective port.
• Defective main control board and its
connections.
• Wrong printer or communication parameters
are set.
Perform hard drive maintenance.
The print processor has an error opening or
reading the temporary files.
• Make sure the TEMP environment variable is set
correctly. User should have sufficient rights to
write to this folder.
• Delete the job and resend it from the
application.
• If the spooler crashes, restart Windows.
There is not enough memory to process and print
a card.
• Make sure that the computer resources are not
being used extensively by other applications.
• Clean up the PC hard drive.
Run the Update utility to update the printer
firmware to make it compatible with the printer
driver. The update process takes several minutes.
• Clean up the PC hard drive.
You may not have restarted Windows after you
installed the driver. Restart Windows and try
printing a card.
4-15