Cam Motor - DataCard CP60 Service Manual

Cam Motor

Removal Procedure
1.
Unplug the printer.
2.
Remove the ribbon cartridge and cleaning roller.
3.
Remove the
4.
Remove the
5.
Rotate the motor gear until the mounting screws are accessible through the
slots.
6.
Loosen the two mounting screws, and lift the motor out of the chassis.
(Unless necessary, don't remove the screws as they can be difficult to
replace.)
Follow-up Procedure
• Tighten the mounting screws to 8 in-lbs.
• Refer to the
• Run the Printhead Cam Test in Diagnostics to verify that the motor is
functional.
6-26
Main Enclosure (p. 6-8).
Transport Assembly
Functional Block Diagram
from the base (p. 6-29).
for replacement details.
Removal and Replacement