Magnetic Clutch/Spring Clutch/Duplex Rollers - DataCard CP60 Service Manual

Magnetic Clutch/Spring Clutch/Duplex Rollers

These three procedures require the same preliminary steps and are grouped
together for convenience.
Removal Procedure
1.
Unplug the printer.
2.
Remove the ribbon cartridge and cleaning roller.
3.
Remove the
4.
Disconnect the duplex interface cable from the interface board.
5.
Remove the
6.
Remove the duplex motor by simultaneously pressing in on the locking tabs,
and rotating the motor.
7.
Disconnect the clutch connector from the clutch.
CP60 and CP60 Plus Service Manual
Main Enclosure (p. 6-8).
Duplex Module (p. 6-61) from the printer.
6-71