Duplex Entry Rocker - DataCard CP60 Service Manual

Duplex Entry Rocker

Removal Procedure
1.
Unplug the printer.
2.
Remove the ribbon cartridge and cleaning roller.
3.
Remove the
4.
Disconnect the duplex interface cable from the interface board, and remove
the
5.
Lift one side of the entry rocker off its pivot pin. As soon as possible, grasp
the pressure spring and remove it before it gets loose.
6.
Repeat the step for the other side, and remove the rocker.
Replacement Note
It is easiest to replace the rocker first and add the springs afterward.
A.
B.
6-68
Main Enclosure
Duplex Module (p. 6-61) from the printer.
Insert the spring over the guide pin.
Compress the spring and slide it into the receiving socket.
(p. 6-8).
Removal and Replacement