Magnetic Stripe Problems - DataCard SD260L User Manual

Magnetic Stripe Problems

To begin troubleshooting a magnetic stripe problem, first print a magnetic stripe test card from
Printer Manager or the Card Printer Driver. For the steps to follow, refer to the "Printer Manager"
section of the printer's Installation and Administrator's Guide or "Print a Driver Sample Card" in
the card printer's Driver Guide.
The printer uses the coercivity set using the LCD panel or in Printer Manager, and the data format
set using Printer Manager.
Problem
Cards are not loaded
correctly.
Cards do not have a
magnetic stripe.
The card has dirt or
damage on the magnetic
stripe.
The magnetic stripe on
the card is low‐coercivity
material and the High
Coercivity setting is
selected.
Message 105 displays.
The magnetic stripe on
the card is high‐coercivity
material and the Low
Coercivity setting is
selected.
The data for this job
includes characters not
allowed by the magnetic
stripe format selected for
the track.
SD260L/SD360/SD460 Card Printers User's Guide
Solution
Load ISO cards with the magnetic stripe (back side) facing
down and toward the right. Refer to "Load Cards" on page
Load magnetic stripe cards in the input hopper. If the cards
have a magnetic stripe, check the quality of the cards. Change
card stock, if needed.
Encode and send a new card to print. If an error message
displays indicating a magnetic stripe problem, run a cleaning
card to clean the magnetic stripe head. Refer to "Run a Printer
Cleaning Card" on page
To use the cards you have, select low‐coercivity encoding.
Refer to the Printer Manager "Printer Setting Menu" in the
Installation and Administrator's Guide for more information.
To encode with high coercivity, obtain cards manufactured for
high‐coercivity encoding. Refer to "Print a Test Card" on
page 22.
To use the cards you have, select high‐coercivity encoding.
Refer to the Printer Manager "Printer Setting Menu" in the
Installation and Administrator's Guide for more information.
To encode with low coercivity, obtain cards manufactured for
low‐coercivity encoding.
Cancel the current print job. Make sure that you know which
characters are allowed on the track. Change the data to be
encoded, and resend the print job. Refer to "Magnetic Stripe
Design" in the printer's Installation and Administrator's Guide
for more information.
30.
23.
47