Input Errors (Is); Duplex Module Errors (Dm) - DataCard CP60 Service Manual

Input Errors (IS)

Error
Code
IS-01206 A card was not picked successfully.
ERR_IH_NO_CARD_PICKED

Duplex Module Errors (DM)

Error
Code
DM The duplex mechanism did not
00760 reach the correct position.
ERR_FLP_POSITION
DM The card is stuck in the duplex
00762 module.
ERR_FLP_CARD_JAM
DM The duplex module is not installed or
00765 detected.
ERR_FLP_NOT_INSTALLED
DM The card is lost in the duplex module.
00767
ERR_FLP_CARD_LOST
CP60 and CP60 Plus Service Manual
Symptom
Symptom
Comments
• Reload the card stock.
• Inspect the card gate in the input hopper
and verify that the spring is in place and
working correctly.
• Check the transport belt and pulleys for
damage.
• Check the belt tensioner to make sure it is
putting tension on the transport timing belt.
• Check the rocker arm springs and make sure
they are placed correctly and not damaged.
• Test the card input sensor to see if it toggles.
• Test the pick motor functions.
• Test the transport motor functions.
Comments
One or more sensor transitions was not
detected.
• Check the flipper for obstructions.
• Check if the clutch is functioning.
• Check if the sensor is functioning.
• Check the duplex motor.
The duplex entry sensor did not clear.
• Check the sensor.
• Check the duplex motor.
The driver attempted to send a duplex job to a
printer not equipped with a duplex module.
Check the duplex interface cable and circuit
board.
The duplex entry sensor was not blocked when
expected.
• Check the sensor.
• Check the duplex motor.
4-17