8
FRU Disassembly/Assembly
Temperature/humidity sensor board
8-22
Phaser 560 Color Printer
1.
Remove the upper and lower rear covers and the left side cover as
explained in the earlier procedure, "The printer cabinet" on page 8-2.
2.
At the lower rear cover, slide out the white plastic housing containing
the temperature/humidity sensor board
3.
Unclip the sensor board from its housing. Disconnect the sensor's
wiring harness. Do not touch the surface of the humidity sensor.
Housing
Lower rear
cover
Figure 8-14 Removing the temperature/humidity sensor board
Reverse these step to install the temperature/humidity sensor board.
Temperature/humidity
sensor board
9697-46