4
Remove the sensor plate (D).
5
Push in on the latches to disconnect the duplex sensor from the printer.
6
Disconnect the cable (E) from the duplex sensor.
Installation notes:
a
Clean the contact surface where you removed the sensor retaining plate, or where you need to install the new
one.
b
Install the new sensor.
Note: Make sure the clamps on the legs of the sensor latch to the metal frame.
c
Remove the backing from the new plate, and place the plate on the surface between the sensor mounting
latches.
Tray present sensor removal
1
Remove the media tray.
2
Remove the imaging unit. See
"Imaging unit (IU) removal" on page
Repair information
303
267.
7527