Min Copy Memory; Num Pad Job Assist; Format Fax Storage; Flatbed Edge Erase - Lexmark CX310 Service Manual

Min copy memory

Values will only be displayed if the amount of installed DRAM is at least twice the amount of the value, that is, at least
200 MB of installed DRAM is required to display the 100 MB selection.
To change this setting:
1
Select Min Copy Memory from the Configuration Menu. [setting's current value] displays.
2
Select one of the three settings: disable, sleep permit or sleep auto
3
Select the minus to decrease the setting's value or the plus to increase the setting's value.
4
Select Submit to save the change.

Num pad job assist

This setting determines if a user can configure and initiate a job using the control panel's hard buttons.
To change this setting:
1
Select Num Pad Job Assist from the Configuration Menu. [setting's current value] displays.
2
Select the minus to decrease the setting's value or the plus to increase the setting's value.
3
Select Submit to save the change.

Format fax storage

This setting enables you to format the non-volatile storage used for storing faxes.
To change this setting:
1
Select Format Fax Storage from the Configuration Menu.
Note: If an advanced password has been established, then you must enter this password to change the setting.
If no advanced password exists, then you can establish one by using the keyboard that appears on the LCD.
2
Select Submit to save the change.
3
Select Back to cancel and return to the Configuration Menu. Formatting Fax Flash DO NOT POWER OFF
appears on the display while the format operation is active.

Flatbed edge erase

This menu item sets the size, in millimeters, of the no print area around a flatbed scan job. Copy jobs will use the setting
or two millimeters, whichever is larger.
To adjust the flatbed edge erase setting, perform the following steps:
1
Select FB Edge Erase from the Configuration Menu. [setting's current value] displays.
2
Select minus to decrease the setting's value or plus to increase the setting's value.
3
Select Submit to save the change.
4
Select Back to cancel and return to the Configuration Menu.
Service menus
221
7527