Lexmark CX310 Service Manual page 293

3
Remove the imaging unit. See
4
Disconnect the three cables (B) from the LVPS.
5
Remove the flatbed scanner assembly. See
6
Remove the two top screws (C) near the front holding the top cover to the LVPS shield.
7
Position the fuser cable (D) so that it can be pulled through from the front of the printer, and guide the cable through
to the front.
Warning—Potential Damage: Be careful not to damage the cable by pulling too hard or cutting the cable
insulation.
"Imaging unit (IU) removal" on page
B
"Flatbed scanner assembly removal" on page
Repair information
293
267.
333.
7527