Fuser service check
Actions
Step 1
Some of these errors are caused by a faulty component on the LVPS. Check
the history file in the printer to verify other occurrences. If there are
others, then replace the LVPS. See
assembly removal" on page
Does this solve the problem?
Step 2
Turn the printer off, and remove the rear cover. See
on page
307.
Check the cable at JFUSES1 for proper connection to the controller board,
the cable for pinch points, and the cable or connector for any other
damage.
Is the cable damaged?
"Low‑voltage power supply (LVPS)
253.
"Rear cover removal"
Diagnostic information
Yes
The problem is solved. Go to step 2.
Replace the fuser
cable.
92
7527
No
Go to step 3.