Using Recycled Paper And Other Office Papers; Using Specialty Media - Lexmark CX310 Service Manual

Using recycled paper and other office papers

As an environmentally conscious company, Lexmark supports the use of recycled office paper produced specifically for
use in laser (electrophotographic) printers. In 1998, Lexmark presented to the US government a study demonstrating
that recycled paper produced by major mills in the US fed as well as non-recycled paper. However, no blanket statement
can be made that all recycled paper will feed well.
Lexmark consistently tests its printers with recycled paper (20–100% post-consumer waste) and a variety of test paper
from around the world, using chamber tests for different temperature and humidity conditions. Lexmark has found no
reason to discourage the use of today's recycled office papers, but generally the following property guidelines apply
to recycled paper.
•
Low moisture content (4–5%)
• Suitable smoothness (100–200 Sheffield units, or 140–350 Bendtsen units, European)
Note: Some much smoother papers (such as premium 24 lb laser papers, 50–90 Sheffield units) and much
rougher papers (such as premium cotton papers, 200–300 Sheffield units) have been engineered to work very
well in laser printers, despite surface texture. Before using these types of paper, consult your paper supplier.
• Suitable sheet-to-sheet coefficient of friction (0.4–0.6)
•
Sufficient bending resistance in the direction of feed
Recycled paper, paper of lower weight (<60 g/m
that is cut grain-short for portrait (or short-edge) fed printers may have lower bending resistance than is required for
reliable paper feeding. Before using these types of paper for laser (electrophotographic) printing, consult your paper
supplier. Remember that these are general guidelines only and that paper meeting these guidelines may still cause
paper feeding problems in any laser printer (for example, if the paper curls excessively under normal printing
conditions).

Using specialty media

Tips on using letterhead
•
Use letterhead designed specifically for laser printers.
•
Print a test page on the letterhead being considered for use before buying large quantities.
• Before loading letterhead, flex, fan, and straighten the stacks to prevent sheets from sticking together.
•
Page orientation is important when printing on letterhead.
Source
Trays
Note: Check with the manufacturer or vendor to determine whether or not the preprinted letterhead is acceptable
for laser printers.
2
[16 lb bond]) and/or lower caliper (<3.8 mils [0.1 mm]), and paper
Printing
One‑sided
General information
26
Printable side Paper orientation
Faceup Load the sheet
with the top edge
entering the
printer first.
7527