Use the following lubricants:
•
IBM no. 10 oil, PN/ 1280443 (Approved equivalents: Mobil DTE27, Shell Tellus 100, Fuchs Renolin MR30)
•
IBM no. 23 grease
•
Grease P/N 99A0394 and Nyogel type 744—Use this type of lubricant to lubricate the Fuser Drive Assembly.
•
Nyogel 744—Use this type of lubricant to lubricate the ITU and Cartridge Drive Assemblies.
The motor drive FRUs contain the proper lubricant in the FRU. Use only the lubricant included.
Cleaning the printer
Cleaning the printer
Note: You may need to perform this task after every few months.
Warning—Potential Damage: Damage to the printer caused by improper handling is not covered by the printer
warranty.
1
Make sure that the printer is turned off and unplugged from the electrical outlet.
CAUTION—SHOCK HAZARD: To avoid the risk of electrical shock when cleaning the exterior of the printer,
unplug the power cord from the electrical outlet and disconnect all cables from the printer before
proceeding.
2
Remove paper from the standard bin, multipurpose feeder, and manual feeder.
3
Remove any dust, lint, and pieces of paper around the printer using a soft brush or vacuum.
4
Dampen a clean, lint-free cloth with water, and use it to wipe the outside of the printer.
Warning—Potential Damage: Do not use household cleaners or detergents, as they may damage the finish of
the printer.
5
Make sure all areas of the printer are dry before sending a new print job.
Maintenance
356
7527