Printer Setup - Lexmark CX310 Service Manual

To run the Flash Test:
1
Select DEVICE TESTS from Diag Menu, and press Select.
2
Select Flash Test, and press Select.
Contents will be lost. Continue? appears.
3
To continue, select Yes, and press Select. To end the test, select No, and press Select.
If you continue, Flash Test Testing... appears.
• If the test is successful, then Flash Test Test Passed appears. Use Format Flash in the Utilities Menu
to reformat the flash card
•
If the test is unsuccessful, then Flash Test Test Failed appears. Replace the flash card.
4
Press Back to remove the message and return to the Device Tests menu.

PRINTER SETUP

•
"Defaults" on page 205
•
"PAGE COUNTS" on page 206
• "Serial Number" on page 206
•
"Engine Setting 1 through 4" on page 206
•
"Model Name" on page 206
• "Configuration ID" on page 206
•
"Transfer Module Barcode" on page 207
•
"Reset Fuser Count" on page 207
Defaults
This setting is used by the printer to determine whether US or non-US factory default values should be used. The
following printer settings have different US and non-US values:
Printer default values
Paper Sizes setting in the General Settings menu
Default Paper Size (paper feeding sources which do not
have hardware size sensing capabilities)
Default Envelope Size (envelope feeding sources which do
not have hardware size sensing capability)
Fax media size
PCL Symbol Set
PPDS Code Page
Universal Units of Measure
Warning—Potential Damage: Modification of the printer setting Defaults causes the NVRAM space to be restored to
the printer's factory settings.
US value
U.S.
Letter
10 Envelope
Letter
PC-8
437
Inches
Service menus
205
Non-US value
Metric
A4
DL Envelope
A4
PC-850
850
Millimeters
7527