Actions
Step 4
Turn the printer off, and remove the rear cover. See
on page
307.
Is the JSP1 cable connector properly connected to the controller board?
Turn the printer on, and check the voltage at JSP1 pin 15.
Step 5
Is the voltage approximately +5 V dc?
202 paper jams
[x]‑page jam, open front door to clear fuser [20y.xx]
1
Open the front door.
CAUTION—HOT SURFACE: The inside of the printer might be hot. To reduce the risk of injury from a hot
component, allow the surface to cool before touching.
Yes
Go to step 5.
"Rear cover removal"
Replace the paper pick
motor drive assembly.
See
drive assembly
(standard tray)
removal" on page
305.
Diagnostic information
53
No
Reset the connector.
Replace the controller
board. See
"Paper pick motor
board removal" on
page
309.
7527
"Controller