Operator Panel Removal (For Cx510 Models Only) - Lexmark CX310 Service Manual

Operator panel removal (for CX510 models only)

Installation warning: Replace one of the following components, and perform a POR before replacing a second
component. Never replace both of the components without performing a POR after installing each one, or the
printer may be rendered inoperable:
•
Operator panel assembly
•
Controller board
Note: The UICC card is part of the operator panel.
Note: The following parts (FRUs) can be accessed from this section:
• 7" display
•
Small interface card
•
Interface cable
•
UICC PCBA
•
Operator panel for 7" display
• User interface support bracket
•
Upper front (operator) cover
•
Speaker
1
Open the front cover.
2
Open the scanner to give access to the bottom operator module.
3
Remove the three screws (A).
4
Carefully separate the module from that scanner and support the right end of the open door without stressing the
cables.
5
Remove the bezel.
6
Remove the screw on the right rear side of the module which secures the bracket to the upper front cover.
Repair information
283
7527