Installing The Baystack 410-24T Switch; Installation Requirements - Nortel BayStack 410 24T Using Manual

This chapter covers the following topics:
•
•
•
•
•
•
Refer to Chapter 3, "Using the Console Interface," to further configure your
BayStack 410-24T switch.

Installation Requirements

Before installing the BayStack 410-24T switch, verify that the package contains
the following items in addition to this guide (see
Note: Be sure that the supplied AC power cord matches the requirements for
your region; see "AC Power Receptacle" on page 1-7.
Install the BayStack 410-24T switch in a ventilated area that is dust free and away
from heat vents, warm air exhaust from other equipment, and direct sunlight.
Avoid proximity to large electric motors or other electromagnetic equipment.
When choosing a location, observe the environmental guidelines listed in
Appendix A, "Technical Specifications." You will need a Phillips screwdriver for
the installation.
309985-B Rev 00

Installing the BayStack 410-24T Switch

Installation requirements
Installation procedure
Instructions for connecting power
Instructions for verifying the installation
Instructions for the initial (standalone) switch setup
Instructions for the initial stack setup
Chapter 2
Figure 2-1).
2-1