Nortel BayStack 410 24T Using Manual page 93

The MultiLink Trunk Configuration screen opens
Trunk Trunk Members (Unit/Port)
----- ------------------------------- ------------ --------------- ------------
1 [ /15 ][
2 [ /25 ][
3 [ /2 ][
4 [ /14 ][
5 [ /22 ][
6 [ / ][
Trunk Trunk Name
----- ------------------
1 [ S1:T1 to FS2 ]
2 [ S1:T2 to S2
3 [ S1:T3 to S2
4 [ S1:T4 to S3
5 [ S1:T5 to S4
6 [ Trunk #6 ]
Enter text, press <Return> or <Enter> when complete.
Press Ctrl-R to return to previous menu.
Figure 1-42. MultiLink Trunk Configuration Screen for Switch S1
Switch S1 is configured as follows:
•
•
Note: The Unit value (in the Unit/Port field) cannot be configured when the
switch is operating standalone. For detailed information about the MultiLink
Trunk Configuration screen fields, see "MultiLink Trunk Configuration" on
page 3-57.
309985-B Rev 00
MultiLink Trunk Configuration
/17 ][ /19 ][ /21 ] [ Normal
/26 ][ / ][ /
/4 ][ / ][ /
/16 ][ / ][ /
/24 ][ / ][ /
/ ][ / ][ /
]
]
]
]
Trunk (read only) indicates the trunks (1 to 6) that correspond to the switch
ports specified in the Trunk Members fields.
Trunk Members (Unit/Port) indicates the ports that can be configured, in
each row, to create the corresponding trunk:
-- Ports 15, 17, 19, and 21 are assigned as trunk members of trunk 1.
-- Ports 25 and 26 are assigned as trunk members of trunk 2.
Introduction to the BayStack 410-24T Switch
STP Learning
]
] [ Normal ]
] [ Normal ]
] [ Normal ]
] [ Fast ]
] [ Normal ]
Press Ctrl-C to return to Main Menu.
(Figure 1-42).
Trunk Mode Trunk Status
Basic [ Enabled
Basic [ Enabled
Basic [ Enabled
Basic [ Enabled
Basic [ Enabled
Basic [ Disabled ]
]
]
]
]
]
1-65