Port-Based Mirroring Configuration - Nortel BayStack 410 24T Using Manual

Introduction to the BayStack 410-24T Switch

Port-Based Mirroring Configuration

Figure 1-50 shows an example of a port-based mirroring configuration where port
23 is designated as the monitor port for ports 24 and 25 of switch S1. Although
this example shows ports 24 and 25 monitored by the monitor port (port 23), any
of the trunk members of T1 and T2 can also be monitored.
Note: Trunks cannot be monitored and trunk members cannot be configured
as monitor ports (see "MultiLink Trunking Configuration Rules" on
page 1-73).
StackProbe Monitor port
(port 23)
Port X
S1
(port 25)
T 1
Port Y
F
(port 24)
F
S2
T2
S3
BS41037A
Figure 1-50. Port-Based Mirroring Configuration Example
Figure 1-51 shows the Port Mirroring Configuration screen setup for this example.
1-81
309985-B Rev 00