Table of Contents
Advertisement
Renumber Stack Units
The Renumber Stack Units screen
configured in the stack.
When selected, this option identifies the unit number of each unit in the stack
configuration by lighting the corresponding number of port LEDs on each unit for
approximately 10 seconds. For example, unit 3 will display three LEDs.
Note: This menu option and screen only appear when the switch is
participating in a stack configuration.
Choose Renumber Stack Units (or press n) from the main menu to open the
Renumber Stack Units screen.
Current Unit Number
-------------------
[
1
]
[
2
]
[
3
]
[
4
]
Renumbering stack units will cause an automatic Reset to Current Settings to
occur across the entire stack.
the new numbering scheme. Check the stack configuration after the reset to
confirm the desired configuration is set.
Are you sure you want to renumber switches with the new settings?
Use space bar to display choices, press <Return> or <Enter> to select choice.
Press Ctrl-R to return to previous menu.
Figure 3-36.
Renumber Stack Units Screen
309985-B Rev 00
(Figure
Renumber Stack Units
MAC Address
----------------------------
00-60-fd-77-a6-0c
00-60-fd-77-a5-f0
00-60-fd-77-a4-4c
00-60-fd-77-ab-84
The current configuration will be adapted to
Using the Console Interface
3-36) allows you to renumber the units
New Unit Number
---------------
Press Ctrl-C to return to Main Menu.
[
1
]
[
2
]
[
3
]
[
4
]
[ No
]
3-89
- Quick Links:
- Front Panel
- Comm Port
Hide quick links:
Advertisement
Table of Contents
