Nortel BayStack 410 24T Using Manual page 298

Using the BayStack 410-24T 10BASE-T Switch
Table E-1. Factory Default Settings for the BayStack 410-24T Switch
Appears in this CI screen
Port Configuration (page 3-52)
High Speed Flow Control
Configuration (page 3-54)
MultiLink Trunk Configuration (page 3-59)
MultiLink Trunk Utilization (page 3-61)
Port Mirroring Configuration (page 3-64)
E-4
Field
Unit
Status
LnkTrap
Autonegotiation
Speed/Duplex
Unit
Autonegotiation
Flow Control
Note: The following two fields only appear when a single Phy
MDA with a separate redundant Phy port is installed.
Preferred Phy
Active Phy
Trunk Members (Unit/Port)
STP Learning
Trunk Mode
Trunk Status
Trunk Name
Traffic Type
Monitoring Mode
Monitor/Unit Port
Unit/Port X
Unit/Port Y
Address A
Address B
(continued)
Default setting
1
Enabled (for all ports)
On
)
Enabled (for all ports
100Mbs/Half (when
Autonegotiation is Disabled)
1 to 8 (depending on
configuration status)
Enabled
Disabled
Right
Read-only field indicating the
operational Phy port (Right,
Left, or None)
Zero-length string
Normal
Basic
Enabled
Trunk #1 to Trunk #6
Rx and Tx
Disabled
Zero-length string
Zero-length string
Zero-length string
00-00-00-00-00-00
(no MAC address assigned)
00-00-00-00-00-00
(no MAC address assigned)
(continued)
309985-B Rev 00