Nortel BayStack 410 24T Using Manual page 152

Using the BayStack 410-24T 10BASE-T Switch
Table 3-3. SNMP Configuration Screen Fields
Field
Read-Write
Community String
Trap #1 IP Address
1
Community String
1
Authentication Trap
AutoTopology
1 The Trap IP Address and Community String fields can be set using a MIB table (in a Nortel Networks proprietary MIB).
The status of the row in the MIB table can be set to Valid or Ignore. If the row status is set to Ignore, the fields appear to
be set when viewed from the console terminal; however, no traps will be sent to that address until the row status is set to
Valid. When a Trap IP Address is entered from the console, the row status is always set to Valid.
3-14
Description
The community string used for in-band read-write SNMP operations.
Default Value private
Range Any ASCII string of up to 32 printable characters
Number one of four trap IP addresses. Successive trap IP address fields are
numbered 2, 3, and 4. Each trap address has an associated community
string (see Community String).
Default Value 0.0.0.0 (no IP address assigned)
Range Four-octet dotted-decimal notation, where each octet is
represented as a decimal value, separated by a decimal
point
The community string associated with one of the four trap IP addresses (see
Trap #1 IP Address).
Default Value Zero-length string
Range Any ASCII string of up to 32 printable characters
Determines whether a trap will be sent when there is an SNMP
authentication failure.
Default Value Enabled
Range Enabled, Disabled
Allows you to enable or disable the switch participation in autotopology,
which allows network topology mapping of other switches in your network.
Default Value Enabled
Range Enabled, Disabled
(continued)
309985-B Rev 00