Trunk Configuration Screen for Switch S2
As shown in
configurations (T2 and T3). Both trunks connect directly to switch S1. As in the
previous screen examples, to set up a trunk configuration choose MultiLink Trunk
Configuration from the MultiLink Trunk Configuration Menu screen.
Figure 1-43
Trunk
Trunk Members (Unit/Port)
----- ------------------------------- ------------ --------------- ------------
1
[
/25 ][
2
[
/1
][
3
[
/
][
4
[
/
][
5
[
/
][
6
[
/
][
Trunk
Trunk Name
----- ------------------
1
[ S2:T2 to S1 ]
2
[ S2:T3 to S1 ]
3
[ Trunk #3 ]
4
[ Trunk #4 ]
5
[ Trunk #5 ]
6
[ Trunk #6 ]
Enter text, press <Return> or <Enter> when complete.
Press Ctrl-R to return to previous menu.
Figure 1-43.
MultiLink Trunk Configuration Screen for Switch S2
Switch S2 is configured as follows:
•
•
309985-B Rev 00
Figure 1-40
shows the MultiLink Trunk Configuration screen for switch S2.
MultiLink Trunk Configuration
/26 ][
/
][
/
/3
][
/
][
/
/
][
/
][
/
/
][
/
][
/
/
][
/
][
/
/
][
/
][
/
Trunk (read only) indicates the trunks (1 to 6) that corresponds to the switch
ports specified in the Trunk Members fields.
Trunk Members (Unit/Port) indicates the ports that can be configured, in
each row, to create the corresponding trunk:
-- Ports 25 and 26 are assigned as trunk members of trunk 1.
-- Ports 1 and 3 are assigned as trunk members of trunk 2.
Introduction to the BayStack 410-24T Switch
on
page
1-63, switch S2 is set up with two trunk
STP Learning
] [ Normal
]
] [ Normal
]
] [ Normal
]
] [ Normal
]
] [ Normal
]
] [ Normal
]
Press Ctrl-C to return to Main Menu.
Trunk Mode
Trunk Status
Basic
[ Enabled
Basic
[ Enabled
Basic
[ Disabled ]
Basic
[ Disabled ]
Basic
[ Disabled ]
Basic
[ Disabled ]
]
]
1-67