Back Panel - Nortel BayStack 410 24T Using Manual

Using the BayStack 410-24T 10BASE-T Switch
Table 1-1. BayStack 410-24T Switch LED Descriptions
Label Type
Link 10 Mb/s port
speed indicator
Activity Port activity

Back Panel

This section describes the BayStack 410-24T switch back panel components
(Figure
Descriptions of the back panel components follow the figure.
1
100-240V~
47-63HZ~
1.5A-600ma
1 = AC power receptacle
2 = RPSU connector
3 = Cascade Module Slot
Figure 1-4. BayStack 410-24T Switch Back Panel
1-6
Color State
Green On
Green Blinking The corresponding port has been disabled by software.
Off
Green Blinking Indicates network activity for the corresponding port. A
1-4).
(continued)
Meaning
This automatic process is a temporary safeguard only. If
the stack configuration loses power, the temporary base
unit will not power up as the base unit when power is
restored. For this reason, you should always assign the
temporary base unit as the base unit (set the Unit Select
switch to Base) until the failed unit is repaired or replaced.
The corresponding port is set to operate at 10 Mb/s and
the link is good.
The link connection is bad or there is no connection to
this port.
high level of network activity can cause the LEDs to
appear to be on continuously.
Redundant Power
2
3
Cascade Module
BS41004A
309985-B Rev 00