For more information about using the accelerator keys, see
Repetitive
Screen Fields and Descriptions
Figure 3-1
the CI screens and their fields, beginning with the main menu.
Main Menu
IP Configuration/Setup
SNMP Configuration
System Characteristics
Switch Configuration
Console/Comm Port Configuration
Identify Unit Numbers
Renumber Stack Units
Display Hardware Units
Spanning Tree Configuration
TELNET Configuration
Software Download
Configuration File
Display Event Log
Reset to Default Settings
1
Only appears when the switch is participating in a stack configuration.
2
Only appears when a gigabit MDA is installed in one or more units in a stack configuration.
Figure 3-1.
Map of Console Interface Screens
The CI screens for your specific switch model will show the correct model name
in the main menu screen title and the correct number of ports and port types in the
Port Configuration screen.
Note: The field values shown in the CI screens in this section are provided as
examples only.
309985-B Rev 00
Tasks" on
page
shows a map of the CI screens. The remainder of this chapter describes
MAC Address Table
MAC Address-Based Security
VLAN Configuration
Port Configuration
High Speed Flow Control
Configuration
1
MultiLink Trunk Configuration
1
Port Mirroring Configuration
Rate Limiting Configuration
IGMP Configuration
Display Port Statistics
Clear Port Statistics
Spanning Tree
Reset
Port Configuration
Display Spanning Tree
Switch Settings
Logout
3-33.
2
Using the Console Interface
"Accelerator Keys for
MAC Address Security Configuration
MAC Address Security Port Configuration
MAC Address Security Port Lists
MAC Address Security Table
VLAN Configuration
VLAN Port Configuration
VLAN Display by Port
Traffic Class Configuration
MultiLink Trunk Configuration
MultiLink Trunk Utilization
IGMP Configuration
Display Multicast Group Membership
BS41045C
3-3