F12; Hard Disk Format - Konica Minolta bizhub 200 Service Manual

10. Tech. Rep. Mode
10.7.6

F12

Functions
• To print on paper with the engine unit and check the printing and paper feeding in the
paper take-up/transport sections.
Use
1. From the Tech. Rep. Mode screen, touch [Function] → [F12] in that order.
Setting/ 2. Select the paper source, and then press the Start key.
Procedure Touch [Duplex] to feed out the paper along the paper path for 2-sided copying.
3. The sequence is halted when the Stop key is pressed or there is no paper.
10.7.7

Hard Disk Format

Functions • To format the hard disk.
• When a hard disk drive is installed.
Use
• When the hard disk is initialized.
1. From the Tech. Rep. Mode screen, touch [Function] → [Hard Disk Format] in that
order.
2. Press the Start key to start the HDD formatting sequence.
Setting/
NOTE
Procedure
• NEVER turn OFF the power while the formatting sequence is in progress.
3. Turn OFF the Main Power Switch, wait for 10 sec. or more, and turn ON the Main
Power Switch again.
10.7.8 FD
Functions • To set the maximum and minimum sizes for manually fed paper.
Use • When the Manual Feed Unit is replaced.
<Maximum Size>
1. From the Tech. Rep. Mode screen, touch [Function] → [FD] in that order.
2. Load paper with a maximum size of 301 mm into the Manual Feed Tray.
3. In the Touch Panel, touch [Maximum Size], and then press the Start key to automati-
cally adjust the setting.
Setting/
Procedure
<Minimum Size>
1. From the Tech. Rep. Mode screen, touch [Function] → [FD] in that order.
2. Load paper with a minimum size of 89 mm into the Manual Feed Tray.
3. In the Touch Panel, touch [Minimum Size], and then press the Start key to automati-
cally adjust the setting.
168
Confidential – for internal use only, do not distribute
Field Service Ver. 2.5 Jul. 2006