Konica Minolta bizhub 200 Service Manual page 489

11. Soft Switch
Pattern 8 2:00 am on last Sunday, November
2
Pattern 9 2:00 am, April 1
2
Pattern 10 2:00 am, April 1
2
Pattern 11 <Until 2006>
2
2:00 am on 1st Sunday, April
<After 2007>
2:00 am on 2nd Sunday, March
MODE
Bit:
198
Bit Feature
7 TX forwarding to adminis-
trator <*>
6 TX forwarding of scanner
function to administrator
<*>
5 Result report TX forward-
ing to administrator
4
NOTE
• (*1): Bit 7 of mode 198 is enabled only when "1 (forwarded)" is specified.
100
Start Time
Factory setting bit
7 6 5 4 3 2 1 0
1 1 0 1 0 0 0 0
Logic
0
Not for-
warded
Not for-
warded
Bit 5-4:
Confidential – for internal use only, do not distribute
Field Service Ver. 2.5 Jul. 2006
2:00 am on last Sunday, February
2:00 am on last Sunday, October
2:00 am, October 1
2:00 am on last Sunday, October
2:00 am on 1st Sunday, November
HEX:D0
1
For- Specifies whether a received document
warded is forwarded to a destination specified by
the administrator.
For- Specifies whether to enable TX For-
warded warding when scanning. (*1)
00 Not output
01 Output for
incomplete TX
10 Always output
11 Not available
End Time
Description
Specifies the print
conditions of trans-
mission reports for TX
Forwarding. (*1)