Konica Minolta bizhub 200 Service Manual page 259

13. Adjust Mode
B. Registration (FD)
• To adjust for variations in the accuracy of IR parts and their mounting accuracy by vary-
Functions
ing the scan start position in the sub scanning direction.
• When the Original Glass is replaced.
Use
• When the CCD Unit is with a new one.
Adjustment
Specifica-
tion
If width B of the output copy falls outside the specified range and
Adjustment
if width B is 19 mm or less: decrease the setting value.
Instructions
if width B is 21 mm or greater: increase the setting value.
1. Position the Test Chart correctly so that the original reference point is aligned with the
scale.
2. Press the Start key to make a copy.
Setting/ 3. Check point B on the image of the copy.
Procedure 4. If width B on the copy falls outside the specified range, enter the Adjust mode.
5. Touch [Scanner] → [Registration] → [FD] in that order.
6. Press the Clear key and enter the value from the 10-Key Pad.
7. Make adjustments until the specifications are met.
210
B
4040F3C524DA
Confidential – for internal use only, do not distribute
Field Service Ver. 2.5 Jul. 2006
• Adjust so that width B on the sample copy
made falls within the following range.
• It is required that Registration (FD) of Printer be
adjusted so as to meet the specifications.
Specifications: 20 mm ± 1.0 mm
Setting Range: -24 to +72 (1 mm = 24 dot)