6. I/O Check
6.
I/O Check
6.1
Check procedure
• To allow sensors to be checked for operation easily and safely, data applied to the IC on
the board can be checked on the panel with the main unit in the standby state (including
a misfeed, malfunction, and closure failure condition).
<Procedure>
1. Display the Tech. Rep. Mode screen.
See P.152 of the main unit service manual.
2. Touch [I/O Check].
3. Touch [Finisher].
6.2
I/O check list
6.2.1
I/O check screen
• This is only typical screen which may be different from what are shown on each individ-
ual main unit.
24
Confidential – for internal use only, do not distribute
Field Service Ver. 2.0 Apr. 2006
4349F3E519DA