Balancer Timing/Clutch Installation - Honda MBX50 Workshop Manual

�HONDA
� MBX50· MBX80
BALANCER TIMING/
CLUTCH INSTALLATION
( 1) Align the punch mark on the primary drive
gear with the index mark on the crankcase.
(2) Align the line on the balancer gear with the
index mark on the crankcase.
CAUTION
Make sure that the aligning line on the balanc­
er gear is in line with the mating line on the
shaft.
! nstall the clutch outer without disturbing the
setups in steps (1) and (2).
Rotate the clutch outer right or left until the gear
engages the sub gear, then push it in the crankcase.
Make sure that the sub gear engages the clutch outer
gear properly.
CLUTCH/KICKSTARTER/GEARSHIFT LINKAGE
( 1)
(6) PRIMARY
DRIVE GEAR
(1) CLUTCH OUTER
(1) SUB GEAR
(3) CLUTCH OUTER
(2) INDEX MARK
BALANCER IDLER
GEAR
(4) INDEX
(2) BALANCER IDLER GEAR
7-10
MARK
PUNCH
MARK