Zyxel One Network (Zon) System Screen - ZyXEL Communications ZyWALL 110 User Manual

Table 322 ZON Utility Icons
ICON
6 Firmware Upgrade
7 Change Admin
Password
8 ZAC
9 Discovery
10 Save Configuration
11 Settings
The following table describes the fields in the ZON Utility main screen.
Table 323 ZON Utility Fields
LABEL
Type
Model
Firmware Version
MAC Address
IP Address
System Name
Location
Status

36.16.1 ZyXEL One Network (ZON) System Screen

Enable ZDP (ZON) and Smart Connect (Ethernet Neighbor) in the System > ZON screen.
See Monitor > System Status > Ethernet Neighbor for information on using Smart Connect
(Link Layer Discovery Protocol (LLDP)) for discovering and configuring LLDP-aware devices in the
same broadcast domain as the ZyWALL/USG that you're logged into using the web configurator.
The following figure shows the System > ZON screen.
Chapter 36 System
DESCRIPTION
Use this icon to upgrade new firmware to selected device(s) of the same model.
Make sure you have downloaded the firmware from the ZyXEL website to your
computer and unzipped it in advance.
Use this icon to change the admin password of the selected device. You must know
the current admin password before changing to a new one.
Use this icon to run the ZyXEL AP Configurator of the selected AP. This is not
supported by the ZyWALL/USG at the time of writing.
You should use this icon first to display all connected devices in the same network
as your computer.
Use this icon to save configuration changes to permanent memory on a selected
device. This is not needed by the ZyWALL/USG at the time of writing.
Use this icon to select a network adaptor for the computer on which the ZON utility
is installed, and the utility language.
DESCRIPTION
This field displays an icon of the kind of device discovered.
This field displays the model name of the discovered device.
This field displays the firmware version of the discovered device.
This field displays the MAC address of the discovered device.
This field displays the IP address of an internal interface on the discovered device
that first received an ZDP discovery request from the ZON utility.
This field displays the system name of the discovered device.
This field displays where the discovered device is.
This field displays whether changes to the discovered device have been done
successfully. As the ZyWALL/USG does not support IP Configuration, Renew IP
address and Flash Locator LED, this field displays "Update failed", "Not support
Renew IP address" and "Not support Flash Locator LED" respectively.
ZyWALL/USG Series User's Guide
718