Bridge Interfaces - ZyXEL Communications ZyWALL 110 User Manual

Table 100 Configuration > Network > Interface > VLAN > Add / Edit (continued)
LABEL
Authentication
Text
Authentication
Key
MD5
Authentication
ID
MD5
Authentication
Key
Related Setting
Configure WAN
TRUNK
Configure Policy
Route
OK
Cancel

9.8 Bridge Interfaces

This section introduces bridges and bridge interfaces and then explains the screens for bridge
interfaces.
Bridge Overview
A bridge creates a connection between two or more network segments at the layer-2 (MAC
address) level. In the following example, bridge X connects four network segments.
Chapter 9 Interfaces
DESCRIPTION
Select an authentication method, or disable authentication. To exchange OSPF routing
information with peer border routers, you must use the same authentication method
that they use. Choices are:
Same-as-Area - use the default authentication method in the area
None - disable authentication
Text - authenticate OSPF routing information using a plain-text password
MD5 - authenticate OSPF routing information using MD5 encryption
This field is available if the Authentication is Text. Type the password for text
authentication. The key can consist of alphanumeric characters and the underscore,
and it can be up to 16 characters long.
This field is available if the Authentication is MD5. Type the ID for MD5
authentication. The ID can be between 1 and 255.
This field is available if the Authentication is MD5. Type the password for MD5
authentication. The password can consist of alphanumeric characters and the
underscore, and it can be up to 16 characters long.
Click WAN TRUNK to go to a screen where you can set this VLAN to be part of a WAN
trunk for load balancing.
Click Policy Route to go to the screen where you can manually configure a policy
route to associate traffic with this VLAN.
Click OK to save your changes back to the ZyWALL/USG.
Click Cancel to exit this screen without saving.
ZyWALL/USG Series User's Guide
242