ZyXEL Communications ZyWALL 110 User Manual page 705

Figure 490 Configuration > System > TELNET
The following table describes the labels in this screen.
Table 313 Configuration > System > TELNET
LABEL DESCRIPTION
Enable Select the check box to allow or disallow the computer with the IP address that matches
the IP address(es) in the Service Control table to access the ZyWALL/USG CLI using this
service.
Server Port You may change the server port number for a service if needed, however you must use the
same port number in order to use that service for remote management.
Service Control This specifies from which computers you can access which ZyWALL/USG zones.
Add Click this to create a new entry. Select an entry and click Add to create a new entry after
the selected entry. Refer to
Edit Double-click an entry or select it and click Edit to be able to modify the entry's settings.
Remove To remove an entry, select it and click Remove. The ZyWALL/USG confirms you want to
remove it before doing so. Note that subsequent entries move up by one when you take
this action.
Move To change an entry's position in the numbered list, select the method and click Move to
display a field to type a number for where you want to put it and press [ENTER] to move
the rule to the number that you typed.
# This the index number of the service control rule.
The entry with a hyphen (-) instead of a number is the ZyWALL/USG's (non-configurable)
default policy. The ZyWALL/USG applies this to traffic that does not match any other
configured rule. It is not an editable rule. To apply other behavior, configure a rule that
traffic will match so the ZyWALL/USG will not have to use the default policy.
Zone This is the zone on the ZyWALL/USG the user is allowed or denied to access.
Address This is the object name of the IP address(es) with which the computer is allowed or denied
to access.
Action This displays whether the computer with the IP address specified above can access the
ZyWALL/USG zone(s) configured in the Zone field (Accept) or not (Deny).
Apply Click Apply to save your changes back to the ZyWALL/USG.
Reset Click Reset to return the screen to its last-saved settings.
Chapter 36 System
Table 310 on page 689
ZyWALL/USG Series User's Guide
705
for details on the screen that opens.