ZyXEL Communications ZyWALL 110 User Manual page 270

Click on the icons to go to the OneSecurity.com website where there is guidance on configuration
walkthroughs, troubleshooting, and other information.
Figure 181 Configuration > Network > Routing > Policy Route
The following table describes the labels in this screen.
Table 114 Configuration > Network > Routing > Policy Route
LABEL DESCRIPTION
Show Advanced Click this button to display a greater or lesser number of configuration fields.
Settings / Hide
Advanced Settings
Enable BWM This is a global setting for enabling or disabling bandwidth management on the
ZyWALL/USG. You must enable this setting to have individual policy routes or
application patrol policies apply bandwidth management.
This same setting also appears in the AppPatrol > General screen. Enabling or
disabling it in one screen also enables or disables it in the other screen.
IPv4 Configuration / Use the IPv4 Configuration section for IPv4 network settings. Use the IPv6
IPv6 Configuration Configuration section for IPv6 network settings if you connect your ZyWALL/USG to
an IPv6 network. Both sections have similar fields as described below.
Use IPv4/IPv6 Policy Select this to have the ZyWALL/USG forward packets that match a policy route
Route to Override according to the policy route instead of sending the packets directly to a connected
Direct Route network.
Add Click this to create a new entry. Select an entry and click Add to create a new entry
after the selected entry.
Edit Double-click an entry or select it and click Edit to open a screen where you can
modify the entry's settings.
Remove To remove an entry, select it and click Remove. The ZyWALL/USG confirms you want
to remove it before doing so.
Activate To turn on an entry, select it and click Activate.
Inactivate To turn off an entry, select it and click Inactivate.
Chapter 10 Routing
ZyWALL/USG Series User's Guide
270