Web Configurator; Web Configurator Access - ZyXEL Communications ZyWALL 110 User Manual

Command-Line Interface (CLI)
The CLI allows you to use text-based commands to configure the ZyWALL/USG. Access it using
remote management (for example, SSH or Telnet) or via the physical or Web Configurator console
port. See the Command Reference Guide for CLI details. The default settings for the console port
are:
Table 2 Console Port Default Settings
SETTING
Speed
Data Bits
Parity
Stop Bit
Flow Control
FTP
Use File Transfer Protocol for firmware upgrades and configuration backup/restore.
SNMP
The device can be monitored and/or managed by an SNMP manager. See
CloudCNM
Use the CloudCNM screen (see
of the ZyWALL/USG by a Central Network Management system.

1.3 Web Configurator

In order to use the Web Configurator, you must:
• Use one of the following web browser versions or later: Internet Explorer 7, Firefox 3.5, Chrome
9.0
• Allow pop-up windows (blocked by default in Windows XP Service Pack 2)
• Enable JavaScripts, Java permissions, and cookies
The recommended screen resolution is 1024 x 768 pixels.
Note: Most screen shots in this guide come from the USG110 and USG60W. Screen shots
for other models may vary a little.

1.3.1 Web Configurator Access

Make sure your ZyWALL/USG hardware is properly connected. See the Quick Start Guide.
1
Chapter 1 Introduction
VALUE
115200 bps
8
None
1
Off
Section 36.13 on page
ZyWALL/USG Series User's Guide
25
Section 43.3 on page
714) to enable and configure management
359.