Active-Passive Mode Edit Monitored Interface - ZyXEL Communications ZyWALL 110 User Manual

Table 231 Configuration > Device HA > Active-Passive Mode (continued)
LABEL
Server Address
Sync. Now
Server Port
Password
Retype to Confirm
Auto Synchronize
Interval
Next Sync Time
Apply
Reset

34.4 Active-Passive Mode Edit Monitored Interface

The Device HA Active-Passive Mode Monitored Interface Edit screen lets you enable or
disable monitoring of an interface and set the interface's management IP address and subnet mask.
To access this screen, click Configuration > Device HA > Active-Passive Mode > Edit.
If you configure device HA settings for an Ethernet interface and later add the Ethernet interface to
a bridge, the ZyWALL/USG retains the interface's device HA settings and uses them again if you
later remove the interface from the bridge. If the bridge is later deleted or the interface is removed
from it, Device HA will recover the interface's setting.
A bridge interface's device HA settings are not retained if you delete the bridge interface.
Chapter 34 Device HA
DESCRIPTION
If this ZyWALL/USG is set to backup role, enter the IP address or Fully-Qualified Domain
Name (FQDN) of the ZyWALL/USG from which to get updated configuration. Usually, you
should enter the IP address or FQDN of a virtual router on a secure network.
If this ZyWALL/USG is set to master role, this field displays the ZyWALL/USG's IP
addresses and/or Fully-Qualified Domain Names (FQDN) through which ZyWALL/USGs in
backup role can get updated configuration from this ZyWALL/USG.
This displays if the ZyWALL/USG is set to use active-passive mode device HA, the
ZyWALL/USG is in the backup role and device HA is enabled. Click this to copy the
specified ZyWALL/USG's configuration.
If this ZyWALL/USG is set to the backup role, enter the port number to use for Secure
FTP when synchronizing with the specified master ZyWALL/USG.
If this ZyWALL/USG is set to master role, this field displays the ZyWALL/USG's Secure
FTP port number. Click the Configure link if you need to change the FTP port number.
Every ZyWALL/USG in the virtual router must use the same port number. If the master
ZyWALL/USG changes, you have to manually change this port number in the backups.
Enter the password used for verification during synchronization. Every ZyWALL/USG in
the virtual router must use the same password.
If you leave this field blank in the master ZyWALL/USG, no backup ZyWALL/USGs can
synchronize from it.
If you leave this field blank in a backup ZyWALL/USG, it cannot synchronize from the
master ZyWALL/USG.
Type the password again here to confirm it.
Select this to get the updated configuration automatically from the specified ZyWALL/
USG according to the specified Interval. The first synchronization begins after the
specified Interval; the ZyWALL/USG does not synchronize immediately.
When you select Auto Synchronize, set how often the ZyWALL/USG synchronizes with
the master.
This appears the next time and date (in hh:mm yyyy-mm-dd format) the ZyWALL/USG
will synchronize with the master.
This appears when the ZyWALL/USG is currently using active-passive mode device HA.
Click Apply to save your changes back to the ZyWALL/USG.
Click Reset to return the screen to its last-saved settings.
ZyWALL/USG Series User's Guide
564