Zyxel One Network (Zon) System Screen - ZyXEL Communications ZyWall 110 User Manual

Table 389 ZON Utility Icons
ICON
9 Configure NCC
Discovery
10 ZAC
11 Clear and Rescan
12 Save Configuration
13 Settings
The following table describes the fields in the ZON Utility main screen.
Table 390 ZON Utility Fields
LABEL
Type
Model
Firmware Version
MAC Address
IP Address
System Name
Location
Status
NCC Discovery
Serial Number
Hardware Version

44.17.3 Zyxel One Network (ZON) System Screen

Enable ZDP (ZON) and Smart Connect (Ethernet Neighbor) in the System > ZON screen.
See Monitor > System Status > Ethernet Neighbor for information on using Smart Connect (Link Layer
Discovery Protocol (LLDP)) for discovering and configuring LLDP-aware devices in the same broadcast
domain as the Zyxel Device that you're logged into using the web configurator.
The following figure shows the System > ZON screen.
Chapter 44 System
DESCRIPTION
You must have Internet access to use this feature. Use this icon to enable or disable
Nebula Control Center (NCC) discovery on the selected device. If it's enabled, the
selected device will try to connect to the NCC. Once the selected device is
connected to and has registered in the NCC, it'll go into the cloud management
mode.
Use this icon to run the Zyxel AP Configurator of the selected AP.
Use this icon to clear the list and discover all devices on the connected network
again.
Use this icon to save configuration changes to permanent memory on a selected
device.
Use this icon to select a network adaptor for the computer on which the ZON utility is
installed, and the utility language.
DESCRIPTION
This field displays an icon of the kind of device discovered.
This field displays the model name of the discovered device.
This field displays the firmware version of the discovered device.
This field displays the MAC address of the discovered device.
This field displays the IP address of an internal interface on the discovered device that
first received an ZDP discovery request from the ZON utility.
This field displays the system name of the discovered device.
This field displays where the discovered device is.
This field displays whether changes to the discovered device have been done
successfully. As the Zyxel Device does not support IP Configuration, Renew IP address
and Flash Locator LED, this field displays "Update failed", "Not support Renew IP
address" and "Not support Flash Locator LED" respectively.
This field displays if the discovered device supports the Nebula Control Center (NCC)
discovery feature. If it's enabled, the selected device will try to connect to the NCC.
Once the selected device is connected to and has registered in the NCC, it'll go into
the cloud management mode.
Enter the admin password of the discovered device to display its serial number.
This field displays the hardware version of the discovered device.
ZyWALL USG Series User's Guide
962