Handlebars Removal; Handlebars Mounting - Suzuki GS850G Service Manual

CHASSIS
I-IANDLEBARS
REMOVAL
Remove the
left
and right rear
view
mirrors.
Shift the clutch cover boot towards the
cable side.
Loosen lock nut Oof
clutch
Iever
portion
to fully
tighten adjuster GI.
Align
the
grooves
of
the adjuster
and lock
nut with that of the clutch lever t o remove
cIutch cable from the clutch lever.
Remove vinyl bands from t h e
left and right
of the
handlebars.
Remove screws for mounting the left
handlebars switc11 to separa tr: the iippcr
and lower portions of
the switch.
Remove screws for mounting the right
handlebars switch to separate the upper
and lower portions of
the
switch.
Remove
themaster cylinder clamp bolts.
Remove the four screws,
two
each on
both
right and left sides, and remove the
handlebars pad.
Remove throttle
grip and throttle
wire
together from the handlehars.
Rernnve the Flandlehars clamping holts and
remove handle holders.
To remove the clutch lever from the handle
bar, take
off the handle grip
before
loosening the clutch lever bolts.
MOUNTING
Pass both the throttle grip and the throttle
wire t h r o t ~ g h t11c handlelrars from the
right
side.
Alipn punch mark
on t h c handlebars
with
the upper end of t h e steering upper bracket
and rnor~n t the handlebars. At tliis time tlie
front and rear holder bolts
must
be
tightened with
the same clearance 3 ) .
1.2-2.0
kg-m
bolts tightening
(8.5-14.5 Ih-ft)
torque: