Removal Of Tube And Tire - Suzuki GS850G Service Manual

*
Insert
an axle spacer into
the front wheel
and insert the
front
axle. Next, From the
right side, assemble the bearing spacer,
cover, axle spacer, washer and
nut
in that
order and temporarily tighten the axle
nut.
See page 11-10 for the order of assembly.
With
the axle
shaft
mounted. place the
front wheel under the front fork and lower
the
jack placed under the engine to
the
front fork.
Do
not change the position
of the
speedometer gear box
(see
page 1 1
- 10).
*
Tighten axle nut.
CA UTION:
To prevent the
axle shafi rotating while
tightening the axle
nut, insert
a
round
bar into
the head of theshaft on the disk
plote side. Rotation of
rhe shaft may
Spud to bending of
the
speedometer
co
hie.
Mount the axle holder on the lower portion
of the front fork.
Maintain a uniform
clearance between
the
axle
holder and the
fork side front and rear (see page
11
- 10).
Axle
shaft tightening
torque
3.6-5.2 kg-m
(26.0-37.5
Ib-ftj
Remove the jack from under the engine.
Axle holder
tightening torque
REMOVAL OF TUBE AND TIRE
* Mark
the position of the tires and
rotational direction of the valve stem with
chalk.
*
Remove the valve cap and
let
out
the air.
Remove the valve fastening nut and fully
loosen the bead protector nu2.
1.5-2.5 kg-m
(
I
l .O- 1 8.0 lb-ft)
Fig, 11-65
Step on the tire bead, push
it
down
and
as
shown below, install the five wheel rim
protectors (special tools) to the wheel.
Fig. 11-66
Using f a t tire
levers,
work the tire bead
over the rim,
starting near tlie valve
stem.
CA UTlO N:
I .
Always
use
the wheel r i m prolecrors.
If
nor, the fire rim
could
be damaged
by the lire lever.
2. The
fire
lever should be upplied over
the wheel rim protectors.
I
-
Wheel rim protector
0994 1-945 10
-