Throttle Cable Mounting - Suzuki GS850G Service Manual

CHA SSIS
A clamp
fixing the
throttle wise is located
in front of the ignition coil. Draw out the
throttle wire over the bent clamp.
Remove
the right I~andlebars switch screws
and separate the
upper and lower portions
of
the handle
switch.
Screw back cable
adjusting
nut
at
the
closing
side
and remove it from
the
throttle
cable guide. Loosen
the cable guide
lock
nut and
remove cable guidemfrom the
handlebars switch.
Remove
throttle
inner
cablemat the
closing
side
from the
throttle
grip
and
remove the cable.
Loosen the cable guide lock nut
at
the
opening side and
remove the cable guide
from the
handlebars switch.
Remove tIlrottle inner cable
Tz? a t the
opening side from the
throttle grip and
remove
the
cable.
-
.
MOUNTING
Mount throttle cable guide
@
at the
opening
side and throttle cable
guide(?,
at
the closing side on
frc handlebars switch
and lightly tighten
the lock nuts.
Mount the
throttle inner
cables
at the
opening and
closing sides respectively on
the
front and rear hoIes
in
the
throttle grip.
*
Fix the riglat handlebar switch en thc
handlebar.
Route both cables through the space
between the tachometer
and
ignition switch
and
then
between
the steering
head pipe
and the right front fork.
*
Fix the throttle wire with the
clamp on the
front
of
the igniton coil.
Mount
the
inner
cable
a1 the opening side
on the lever at
the rear side. Mount
the
cable
adjuster
on
the bracket and fix it with
the upper and lower nuts.
Mount the inner cable
at
the closing side on
the lever at
the
front side.
Mount the cable
adjuster on t h e bracket
and fix
i t
with the
upper and lower
nuts.
If
it
is
difficult
to
mount
the
inner cable
on
the lever, turn the
throttle grip te
the
full
open position and
then mount
the
inner
cabIe.
Adjust the
throttle cable
(see page 3-13).
Mount
the
fuel tank.