Crankshaft Inspection - Suzuki GS850G Service Manual

-
ENGINE
CRAMSEZAlT
INSPECTION
Big end side clearance
Measure the big end side clearance of the
connecting rod with a thickness gauge as
shown. Replace the crankshaft if the clearance
exceeds
the limit.
Big end
side
clearance
Standard
26 in)
1
in)
Connecting rod big end wear
Support the crankshaft at both ends with V-
blocks, and measure the amount
of
wear on
the connecting rod big end. If worn more than
specification, replace the crankshaft.
Thickness
gauge:
Connecting rod big end wear
09900-20803
I
Crankshaft
runout
Support
the crankshaft with "V"' blocks
as
shown. with
the
two
end bearings resting on
the blocks. Rig up the dial gauge,
as
shown,
and rotate the crankshaft slowly to read the
runout.
RepIace the crankshaft
if ~thr: runout is greater
than the limit.
Crankshaft runout
Service
Limit
0.08 m m (0.003 in)
Fig. 7-202
Service Limit
Fig. 7-20]
0.05 rnm 10.002 in)