Automatic Advancer For Contact Breaker Removal; Automatic Advancer For Contact Breaker Installation; Dismantling Of Automatic Advancer - Suzuki GS850G Service Manual

ENGINE
INSTALLATION
Installation
i s
carriea our in tne reverse
order of removal.
Condenser lead wire is mounted on the
outer side of the insulated washer.
AUTOMATIC ADVANCER FOR
CONTACT BREAKER
REMOVAL
Remove points cover and gasket.
Use
a
wrench
to
hold the crank hirning nut
while removing automatic advancer
mounting bolt.
Fig. 7-126
Remove mounting- screws
L U I
C U I I L ~ L L
breaker assembIy and then remove the
assembly and the
automatic
advancer.
I /
Fig. 7-127
INSTALLATION
Installation is carried out in the reverse
order of removal.
*
Make sure to fit the slot on the back
surface
of the automatic advancer over the locating
pin
a t
the end
of
crankshaft and
the
groove
o f the crankshaft turning nut.
Fig. 7-128
Adjust
ignition timing (see page 3-9).
DISMANTLmG
OF
AUTOMATIC
ADVANCER
Extract cam from the automatic advancer
body
and wipe
off
dirt,
etc.,
completely
from
the cam.